Configuring the Agent Using the Wizard

This section describes how to use the wizard to configure the Hitachi TrueCopy agent in an application service group.

1. Run the wizard on a system attached to the array. Verify Hitachi RAID Manager is installed on the system where you run the wizard.
2. Set the DISPLAY variable and start the HTC Configuration wizard as root.
   # hawizard htc
3. Read the information on the Welcome screen and click Next.
4. In the Wizard Options dialog box, select the application service group to which you want to add an HTC resource.

   ---

     Note    The wizard displays service groups having disk group resources; it does not display service groups having HTC resources.

   ---

5. In the Select Device Group dialog box, specify the device group from the Hitachi array for which the HTC resource is to be added.

   

   Click the thumbnail above to view full-sized image.

   1. In the Base Directory field, specify the path where the CLI package for the Hitachi array is installed. The default location is /HORCM/usr/bin.
   2. From the Device Group list, select a device group.

   If the wizard does not display the required device groups, verify the HTC instance is running and click Discover.

   3. Select the instance number for the device group.
   4. Click Next.

6. Select the replicated diskgroups and click Next.

   

   Click the thumbnail above to view full-sized image.

   If you are adding an HTC resource in a service group configured in a replicated data cluster, proceed to the next step. Otherwise, proceed to step 8.

7. In the System Zones Selection dialog box, specify the systems in each zone of a replicated data cluster.

   

   Click the thumbnail above to view full-sized image.

   1. If you had configured SystemZones in the application service group, verify the configuration. Use the arrows to move systems to their respective zones.
   2. Click Next.
8. In the Service Group Summary dialog box, review the service group configuration and change the name of the HTC resource, if desired.

   

   Click the thumbnail above to view full-sized image.

   1. To change the name of the HTC resource, select the resource name and either click it or press the F2 key. Press Enter after editing the resource name. To cancel editing a resource name, press Esc.
   2. Click Finish.

   The wizard starts running commands to add the HTC resource to the service group. Various messages indicate the status of these commands.

9. In the Completing the HTC Configuration Wizard dialog box, select the check box to bring the service group online on the local system.
10. Click Close.