Use the shownetwork command to display the current ALOM network configuration.
Note: If you changed the ALOM network configuration since the last time you booted ALOM, the output from this command might not show the updated configuration information. Reboot ALOM to see the changed configuration.
Note: You do not need user permissions to use this command.
At the sc> prompt, type the following command:
sc> shownetwork option
where option is -v, if desired.
The command output appears similar to the following example, with the actual IP addresses, netmask, and Ethernet addresses in your network configuration in place of xxx.xxx.xxx.xxx.
sc> shownetwork
SC network configuration is:
IP Address: XXX.XXX.XXX.XXX
Gateway address: XXX.XXX.XXX.XXX
Netmask: XXX.XXX.XXX.XXX
Ethernet Address: XX:XX:XX:XX:XX:XX
The shownetwork command uses one option: -v.
If you type shownetwork -v, ALOM returns additional information about your network, including information about your DHCP (Dynamic Host Configuration Protocol) server, if you have one configured.